UNDERPINNING - CANTILEVER BEAMS

TECHNICAL DATA SHEET 1.3

 

This method stabilises existing wall foundations either internally or externally whichever the most appropriate. Two mini-piles are installed, one compression and one tension. A pocket is broken out into the existing wall and a reinforced concrete beam is cast linking the two piles.

 

This system is used where traditional underpinning is not appropriate due to the existing foundations being deep, or that good-bearing strata is so deep that it is uneconomical to dig. (Depths greater than 1.5m). Or needle beams cannot be used due to access constraints.

 

Reducing the span between cantilevers can accommodate high loads. However, the bearing capacity of the underlying strata will determine the number, diameter and spacing of piles used.

 

Load Capabilities using mini-piles: 

 

Piles are installed at approximately 1.0m 1.5m centers and 1.2m apart determined by loadings. Then pockets are broken out and reinforced beams are placed to pick up the walls. Beams are usually cast alternate.

 

 

Advantages of this system are:

Click here for printer friendly version of this page

 

Mini-piling
underpinning

Tel: 0114 2442963    Fax: 0114 2441768     E-Mail: info@gbanksltd.com

                  

 

                                                                                                                                                                                                                        Site Ma
p
civil engineering